Welcome to 3D Wall Panels | ProForm

Set of forms "Hive" for casting 3D partitions

Set of forms "Hive" for casting 3D partitions
Set of forms "Hive" for casting 3D partitions Set of forms "Hive" for casting 3D partitions Set of forms "Hive" for casting 3D partitions Set of forms "Hive" for casting 3D partitions Set of forms "Hive" for casting 3D partitions Set of forms "Hive" for casting 3D partitions Set of forms "Hive" for casting 3D partitions Set of forms "Hive" for casting 3D partitions
Brand: Харьков-Проформа
Product Code: 502
Availability: 1000
Price: $89.90
Ex Tax: $89.90

10 or more $75.00
Qty:     - OR -   Add to Wish List
Add to Compare

Set (2 forms) "BEE" or "HIVE"  for casting decorative 3D partitions. Suitable for gypsum and cement mortars.

  • - Mold material - ABS plastic 2 mm thick
  • - Includes 2 shapes mirrored from each other
  • - Form size 540 * 440 * 100 mm
  • - Weight of the set 1200 grams
  • - We guarantee 100 filling cycles
  •  
  • - The size of the finished block 500 * 400 * 100 mm
  • - Weight about 13 kg

How are the blocks produced?

Lubricate the molds (engine oil + diesel fuel 1k1 in case a cement / special grease solution based on wax or water-soluble fats) in a small layer, fill it with gypsum or cement. We expect a sufficient hardness of the product and remove it from the mold. Since the molds are made of plastic - there may be slight difficulties in the removal, but this should not be if you do everything correctly - carefully lubricate the molds, work at room temperature, etc. The second half is poured into the second form, we wait a bit for the mixture to thicken and put the first half properly on the filled second half - we glue both parts together. They waited, the product hardened, the block was removed from the mold. It may be necessary to clean or cut off the joints - this should be done immediately or for a short time, when the gypsum is still wet and easily cut.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: