Welcome to 3D Wall Panels | ProForm

A set of "CLUB" forms for creating 3D partitions

A set of "CLUB" forms for creating 3D partitions
A set of "CLUB" forms for creating 3D partitions A set of "CLUB" forms for creating 3D partitions A set of "CLUB" forms for creating 3D partitions A set of "CLUB" forms for creating 3D partitions
Brand: Харьков-Проформа
Product Code: 500
Availability: 1000
Price: $83.70
Ex Tax: $83.70

10 or more $70.00
Qty:     - OR -   Add to Wish List
Add to Compare

Kit (2 forms) "CLUB" for casting decorative 3D partitions. Suitable for gypsum and cement mortars.

- Mold material - ABS plastic 2 mm thick
- Includes 2 shapes mirrored from each other
- Form size 430 * 280 * 100 mm
- Weight of the set 1200 grams
- We guarantee 100 filling cycles

- The size of the finished block 390 * 240 * 100 mm
- Weight about 8 kg

How are the blocks produced?

Lubricate the molds (engine oil + diesel fuel 1k1 in case a cement / special grease solution based on wax or water-soluble fats) in a small layer, fill it with gypsum or cement. We expect a sufficient hardness of the product and remove it from the mold. Since the molds are made of plastic - there may be slight difficulties in the removal, but this should not be if you do everything correctly - carefully lubricate the molds, work at room temperature, etc. The second half is poured into the second form, we wait a bit for the mixture to thicken and put the first half properly on the filled second half - we glue both parts together. They waited, the product hardened, the block was removed from the mold. It may be necessary to clean or cut off the joints - this should be done immediately or for a short time, when the gypsum is still wet and easily cut.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: